- Stock: In Stock
- Model: EnStation 2
Technical Specifications
Hardware
RF: 2.4 GHz Frequency Band
Standard: IEEE 802.11b/g/n
Radio I: 11b/g/n: 2.412~2.484 GHz
Data Rate: Up to 300 Mbps in 2.4 GHz
Memory: 128MB
Flash Memory: 16MB
Transmit Power:
Up to 26 dBm
Up to 400 mW
Radio Chains/Spatial Streams – 3x3:3
Supported Radio Technologies:
802.11b: Direct-sequence spread-spectrum (DSSS)
802.11n: Orthological Frequency-Division Multiplexing (OFDM)
802.11n: With 5/10/20/40 MHz Channel Width
Supported Modulation Types:
802.11b: BPSK QPSK, CCK
802.11n: BPSK, QPSK, 16-QAM, 64-QAM
Supported Data Rates (Mbps):
802.11b: 1, 2, 5.5, 11
802.11g: 6, 9, 12, 18, 36, 48, 54
802.11n: 6.5~300 (MCS0 to MCS15)
Physical Interface
Two (2) 10/100 BASE-T Ethernet Ports
One (1) Port supports 24V Proprietary PoE Input
One (1) Port supports extension of an Internet signal
Reset Button
LED Signal
Power
LAN 1
LAN 2
WLAN
Antenna
One (1) Internal High-Gain Directional Antenna
13 dBi GHz Antenna
Azimuth Beam Width (Horizontal): 18°
Elevation Beam Width (Vertical): 30°
Point-to-Point Transmission for Long Range Distances
2.4 GHz (Point 1)
Peak Antenna Gain: 13 dBi
Polarization: Linear
Horizontal Beam Width: 67°
Elevation Beam-Width: 33°
VSWR: 1:2.0
2.4 GHz (Point 2)
Peak Antenna Gain: 13 dBi
Polarization: Linear
Horizontal Beam Width: 61°
Elevation Beam-Width: 35°
VSWR: 1:2.0
Power Requirements
Power Source (PoE Injector):
24V/.6A Proprietary Compliant Source
Active Ethernet (Power over Ethernet, PoE)
Power Consumption: 7.2 W
Peak Power Consumption: Up to 34 W
Management
Auto Channel Selection
Settings varies by Regulatory Domains
Operation Modes
Access Point, Client Bridge, WDS Bridge
LAN
IP (check validity and DHCP server IP range) MAC
SSID
BSSID
Supports Four (4) SSIDs
VLAN Tagging
Independent VLAN settings cab be enabled/disabled
Any packet that enters the device without a VLAN tag will have a VLAN tag inserted via a PVID (Ethernet Port VID)
VLAN Pass-through
VLAN Pass-through over WDS Bridge
SNMP & MIB
V1/v2c/v3 Support
MIB I/II and Private MIB
QoS
Compliant with IEEE 802.11e Standard
Other Management Features
Save Configurations as Default
Saves the customized configuration as the default value for different customer demands
Client Traffic Status
Reports various information in a timely manner as required by the administrator
Management (cont.)
Control Features
RADIUS Accounting
Helps operators to offload 3G to Wi-Fi seamlessly
Settings vary by Regulatory Domains
Distance Control (Ack Timeout)
Multicast Supported
Wi-Fi Scheduler
Sets the Schedule for rebooting the device
Security
WEP Encryption: 64/128/152 bit
WPA/WPA2 Enterprise (WPA-EAP using TKIP or AES)
Hide SSID in Beacons
MAC Address Filtering
Filter up to 50 MAC addresses
Wireless STA (Client) Connection List
Reports various information in a timely manner as required by the administrator
802.1x Authenticator
Environmental & Mechanical
Temperature Range
Operating: -4º~140ºF/-20ºC~60ºC
Storage: -22Fº~176ºF/-30ºC~80ºC
Humidity (non-condensing)
Operating: 90% or less
Storage: 90% or less
Waterproof
IP55-Rated Enclosure
Certifications
FCC, CE
Maximum data rates are based on IEEE 802.11 standards. Actual throughput and range may vary depending on distance between devices or traffic and bandwidth load in the network. Features and specifications subject to change without notice. Trademarks and registered trademarks are the property of their respective owners. For United States of America: Copyright ©2014 EnGenius Technologies, Inc. All rights reserved. Compliant with FCC - This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his/her own expense.
Dimensions & Weights
Package Contents
EnStation2 Outdoor CPE
PoE Injector (EPE-1212) with Power Adapter (24V/.6A)
Pole/Wall Mounting Kit
Mounting Screw Set
Quick Installation Guide
Warranty
1 Year
Suggested Related Products
EGS5212FP 8-Port Gigabit PoE+ Layer 2 Switch with 2 Gigabit Uplink Ports & 2 Dual-Speed SFP
EGS7228P 24-Port Gigabit PoE+ L2 Managed Switch with 4 Dual-Speed SFP
EGS7228FP 24-Port Gigabit PoE+ L2 Managed Switch with 4 Dual-Speed SFP
EGS7252FP 48-Port Gigabit PoE+ L2 Managed Switch with 4 Dual-Speed SFP